Ruger rifle mounts Weaver style

RUGER Mini 14 Scope Mount

RUGER Mini 14 Ranch Rifle
Deerfield, Mini 30, PC-40, PC-9
99/44, Carbine

Ruger Mini 14 Scope Mount Ranch increases your scope options when you install this lightweight, PICATINNY style rail on your Mini 14 Ranch Rifle. Lets you mount mini or short length scopes as well as Aimpoint red dots without permanent modifications or drilling and tapping. Keeps the scope low over the centerline of the receiver to maintain optimum eye and scope alignment. This Ruger Mini 14 scope mount also has an enhanced ejection scallop for improved brass ejection. Multiple cross slots allow adjustment for maximum eye relief. Accepts all Weaver-style and Picatinny rings and accessories. 5" long, silver or black, matte anodized finish, weighs 2.6 ounces.

Ruger Ranch Rifle Scope Mount WEIG-A-TINNY

Ruger Mini 14 scope mount has been redesigned so you do not have to remove your rear peep sight to install

In recent years the Ruger Mini 14 has become a quite popular rifle with hunters, plinkers and even home defense. Adding a scope mount and scope or red dot sight is a great addition to any Mini 14, Mini 30, PC-9, PC-40 and carbine.


Please Note:

The iron sights are rendered non functional when this scope mount is installed. The scope mount blocks the line of sight to the iron sights. This is done to keep the scope as close as possible to the centerline of the barrel bore. This minimizes point of impact changes at various distances.
RUGER Mini 14 Scope Mount Ring Special
Fits the following Ruger Ranch Rifles
RUGER Mini 14 Ranch Rifle ** See note below
Mini 30, PC-40, PC-9
Scope Mount Only Scope Mount And
Scope Ring Combo

Save 20% On The Rings
RANCHPS  Picatinny Style- Silver $49.95
Add To Cart
Add To Cart
RANCHP Picatinny Style- Black $49.95
Add To Cart
Add To Cart
View Cart
Small Screw
Thread Lock
1 ml Tube
Add To Cart

Allen Wrench Set
1/16, 5/64, 3/32, 7/64, 1/8
Covers all Weigand Scope Mounts and Rings
Add To Cart

** NOTE: We have seen burrs on the inside of the scallops on top of the receivers. If the key on the bottom of our mount will not easily slip into the scallop use a file to deburr inside of the cavity (scallop) on the rifle. The burr is from the serrations that run along the top of the receiver. When machined the process drags a burr into the scallop cavity.

Picatinny Specs Ruger Mini 14 Scope Mount 

Weigand Mini 14 Scope Ring Special

Customer service
Home page